--------------------------------------------------------------
For SAMSON DD 373x-5 rev 2 non enhanced DD (Tokenizer 4)
--------------------------------------------------------------
Lookup table for the Simulation of Status Messages
in directory <Configure/Setup - Simulation>
--------------------------------------------------------------
Visible text| FF device |     Simulated Status Message        |
 in DD/HMI  | com. data |                                     |
--------------------------------------------------------------
     0  -------    0  ------- No simulation
    
   150  -------  150  ------- Status error: Device not initialized
   151  -------  151  ------- Status error: Internal solenoid valve not active
    
   155  -------  155  ------- Oper. error: Mode unequal AUTO
   156  -------  156  ------- Oper. error: Control loop
   157  -------  157  ------- Oper. error: Zero point
   158  -------  158  ------- Oper. error: Autocorrection
   159  -------  159  ------- Oper. error: Fatal error
   160  -------  160  ------- Oper. error: Total valve travel exceeded
   161  -------  161  ------- Oper. error: Extended diagnosis
    
   165  -------  165  ------- HW error: x-signal
   166  -------  166  ------- HW error: i/p converter
   167  -------  167  ------- HW error: Hardware
   168  -------  169  ------- HW error: Data memory
   169  -------  169  ------- HW error: Control calculation
   170  -------  170  ------- HW error: Program load error
    
   173  -------  173  ------- Init. error: x > range
   174  -------  174  ------- Init. error: Delta x < range
   175  -------  175  ------- Init. error: Mechanics/Pneumatics (Attachment)
   176  -------  176  ------- Init. error: Initialization time exceeded
   177  -------  177  ------- Init. error: Initialization/int. solenoid valve/forced venting
   178  -------  178  ------- Init. error: Travel time too short
   179  -------  179  ------- Init. error: Pin position / safety switch
   180  -------  180  ------- Init. error: No emergency mode
   181  -------  181  ------- Init. error: Reference test aborted
    
   185  -------  185  ------- Data error: Inconsistent data memory

   187  -------  187  ------- Temperature below -40C/-40F
   188  -------  188  ------- Temperature above +80C/+176F

   190  -------  190  ------- Air supply: Perhaps modified TEST
   191  -------  191  ------- Trend range: Shifting working range closing pos.
   192  -------  192  ------- Leakage pneumatics: Perhaps existing TEST
   193  -------  193  ------- Limit working range: Down
   194  -------  194  ------- Trend end pos.: ZP-shift monotone down; average > reference
   195  -------  195  ------- Mech. connection Positioner/Valve: No optimal travel transmition TEST
   196  -------  196  ------- Range: Mostly near closing position
   197  -------  197  ------- Friction: Much higher over whole range
   198  -------  198  ------- Spring: Perhaps spring stiffness reduced TEST
   199  -------  199  ------- Inner leakage: Alarm limit 2 exceeded
   200  -------  200  ------- External leakage: Perhaps soon expected
   201  -------  201  ------- PST/FST: Status active
   202  -------  202  ------- Open/Close: Status active


